Pulley Lagging manufacturers

Diamond pulley lagging helps increase friction coefficient between pulley and conveyor belt and reduce conveyor belt slippage. Our diamond rubber lagging is produced with CN bonding layer, which ensures excellent bonding between rubber lagging and pulley, and special compound of pulley lagging rubber sheet makes sure higher wear resistance. Installation process: cold bonding pulley lagging Physical Properties : 1.Elastomer: NR / SBR blend 2.Hardness: 65 卤 5 Shore A 3. Tensile strength: 18 MPa 4. Elongation at break: >500% 5. Abrasion loss: 90mm3 Available Sizes: Thickness:8mm,10mm,12mm,15mm,20mm,etc Width:800mm, 1000mm, 1200mm, 1400mm, 1600mm, 1800mm, 2000mm, etc. Length:10m roll. Comparison between cold bond rubber pulley lagging and traditional pulley lagging No.ItemRubber pulley laggingTraditional pulley lagging 1Bonding strength to pulley12.6N/mm3~8N/mm 2Pressure when vulcanizing50kg/cm6~8kg/cm 3Abrasion resistance.High compactness of rubber, and high wear resistance.Low compactness of rubber, and bad wear resistance. 4Service lifeCan use for longer time than traditional pulley laggingShort service life. 5Friction CoefficientHigh friction coefficient reduces pressure to rubberLow friction coefficient increases pressure of rubber 6Rubber HardnessGood rubber elasticity can avoid sticking.Rapid aging of rubber leads to higher hardness, then material are easily stick. 7Bonding methodIt can be bonded on site, convenient and efficient, cost less.Procedure is complex.Pulley Lagging manufacturers website:http://www.bestceramicwearliner.com/pulley-lagging/